Echa un vistazo a esta página aquí. http://wiki.eleksmaker.com/doku.php?id=elekcam
Allí usted puede descargar el software y se explica exactamente cómo instalarlo.
Alternativamente a EleksCam también puede instalar software alternativo. Está en la misma página más abajo, bajo "-Otro software-"
@walter76 Yes, but it's not public yet. I will publish it this week, maybe later today if I have time. It uses D9=X, 10=Y and 12=Z and does the Z axis homing and then XY together as this is normal for CNC. It also has the EleksCNC defaults of 400 steps/mm and lower speed/acceleration.
Is this what you want or you prefer all on D9, I think that should be possible but would require separate homing, Z then X then Y?
The forum now has a wiki page that you can see at the top of the Eleksmill forum. The link to the forum is below, which should include assembly instructions, electrical connections, and some software setup stuff. As for operating the machine, you learn as you go based on the software you choose to control it. If you posted more specifically the OS you use and what GUI you use to control the board, it would make it easier to help. For example, I use Linux and Candle control software (I am in the process of upgrading the nano clone to Grbl 1.1e/f from Grbl 0.9j).
Used hardware I ordered from McMaster Carr and Misumi linear bearings to rebuild my machine (also ordered some stainless steel rods from Misumi that havent arrived yet). In the past, I have done test cuts where I drive the engraving bit too far into the copper just to see it mill the right directions (seen as the large copper cuts in the photo). Today, I z-probed one position and then milled the copper to a little bit larger than the copper thickness, here are the results. As you can see, I need to use the height map so that all areas are cut, but the results are very promising.
@DCJones Sorry, I've been away for a little. You can directly alter these settings in candle. I have attached a generic screenshot of Candle from the github page. In the bottom right corner, you can see a little typing interface with the paper airplane beside it. Type the command you want to send here and push the paper airplane icon for sending.
@Zax Yes the motor does not turn or very difficult I tried to turn it with a clamp It is sure that if I connect it nothing will turn and it will warm I think the bearing is stuck.
I will order one on the site it will go faster, It's been two days since I reported the problem to BangGood they told me to be patient
Thanks a thousand times for your help
Anyway, confirmed that A5 is shorted to the innermost PR pin, and ground is shorted to the outermost PR pin. I made the connections and tested with Candle, I can z-probe. Now playing with the height map.
Disabled Categories are greyed out
This topic will be moved to the category
Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.