hello,

I start in this domain of cnc machine : i discover the grbl software and i have a elekslaser A5.

If i well understood, i must configure the config parameters of GRBL, in accord with mechanical caracteristics of this machine (https://github.com/gnea/grbl/wiki/Grbl-v1.1-Configuration)

And , in particular, these parameters :

$100 X steps/mm $101 Y steps/mm $102 Z steps/mm

$110= X Max rate, mm/min

$111= Y Max rate, mm/min

$112= Z Max rate, mm/min

$120= X Acceleration, mm/sec^2

$121= Y Acceleration, mm/sec^2

$122= Z Acceleration, mm/sec^2

$130= X Max travel, mm

$131= Y Max travel, mm

$132= Z Max travel, mm

Could you give me the good values to put to this parameters ?

I don't have information about the stepper motors used with elekslaser A5 to precise them.

(are they identicals for A3 ?)

Thanks