I think I have the mama so,
so I tried to unplug the cutter, shut shown the program, put the 2 buttons on the off position and try to run it again, but now it won't turn on the burning laser and stays in low power unless I plug the laser to the 12v power supply
overall, it looks like the computer can't control the on or off of the laser
no matter what I do I can't control the laser power from the computer
I can't get pulse "dots" to work
Su laseril on kaks nuppu. Kasuta neid ja natuke loogilist mõtlemist. SW2 lülitab laseri töörežiime, SW1 laserit sisse ja välja. Proovi kõigepealt lülitada sisse teine töörežiim ja siis lülita laser välja ning proovi BenBoxist, kas asi töötab.
Ehhee. As I told - it is a challenge. My Note 5, that usually not let me down so far, fails, if there is a need to capture a laser dot. I must prepare my mirror camera, because I don't want give up. But anyway - my laser dot is exactly as yours. So I don't want capture that dot to post it there, but just for willfulness.
How about this? Despite proper assembly and testing, my A3 2500mW unit fails to work AT ALL. Banggood seems to rely on boilerplate email (non)responses, having requested and received videos FOUR times (twice claiming they couldn't open them) and pushing me off to this forum for answers, instead of sending replacement parts. Since I have had good luck with buying handtools and such like, I'm willing to give them the benefit of the doubt, but only so far. Now they want a screenshot that I've gone to the forum. Let's see what happens next...