@EleksMaker-Z Hi Z, my question is about the assembly of mount module laser, Not is easy to plug and play, right?
I need to release the screws and put de laser module. I did imagine before to receive the machine that a simple push and put, hehehe, easy to my wife change the pen module for a laser module.
@hidoba I had the same problem - if the screws fixing the moving carriage plates together are too tight, they will pull the linear bearings out of alignment and movement will be scratchy and rough - undo the screws a bit until the X Y movement is smooth by hand
I attached it to opposite side of moving hand. Yes - if you use it by that way, you must reverse X and Y axis in EleksCAM...
but I have not tried it myself yet because I must do it somewhere else, as 5.5 laser burns instantly and makes very quickly enough smoke to alarm my smokededector.
Disabled Categories are greyed out
This topic will be moved to the category
Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.