be careful! If you accidentally engrave the living room hardwood, your wife will kill us all!
long time ago , we just a smalllllllll company , and due to the very low prices we dont have much money , we set up this forum in order to gather the information for our customer directly , and i must say i am sorry we cant bring you the most very detailed description of the assembly today .
but in the past two month (since our forum online), we are trying to fix everything we come up with . And promote some performance.
And now , we are trying to bring the very detail assembly instructions and include the problem your folks come up with.
I feel terribly sorry for everyone.
and for a DIY KIT products , any one can have different problem. we try to collect these big data.
I promise we will fix these problems as soon as possible.
i think the problem is laser moudle . you can tell the banggood about this
you can try to connect them whit the screen shot above , BTW when did you bought it?
okey , the laser seems broken , where did you buy it?
can you take a small video of your laser and control board test?thx
did you press the weak button on laser modue?
But , if you connect the laser module the Mana SE board D4 LED become flash it may means something wrong with the laser or connecter.
could you please try test the laser module like i just said(only connect the power) ? if something wrong , please tell me , we will try to help you , thx
So... on further testing: putting 12v across the main wires into the laser will make it fire but I notice the "dot" when focused isnt actually a dot... its a small line?? Is this an issue?
When I put 12v down the cable to the laser without connecting the pin noted VCC it gives a red led or flashing red led if the low light button is pressed.
I am assuming that this means it is the board itself that is faulty... would anyone like to confirm this for me please?
nope, if you get a small line instead of dot , it means you didnt focus the laser moudle , you need turn the knob which is in front of the laser module and meanwhile turn on the weak light button on the laser module .
until you get a dot . Done
and i think you can try another material ， and recheck the laser focus , make speed a littel slower ,
BTW , the image choose is important , some pic may not be best choose for carving.
i think i have tried the material like you use few years ago, and here is the result
Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.