Mystery line appears when importing Inkscape DXF to T2Laser



  • I'm just getting used to my new A3 Pro and am wanting to use it in my Pepakura projects. I've exported my prints as vector PDFs into Inkcape, which then is used to make them into DXF files. While this seems to be working, an odd line has appeared in T2Laser between two points that cross my work piece. Is there any way to remove this line? 0_1513921459766_Laser DXF Error.PNG


  • Developer of T2Laser Software

    @GunGryphon Wow, it took me a minute to see that. It was like one of those "spot the difference" puzzles.

    I'm not sure if you were following my PDF on exporting DXF from Inkscape but if not, make sure you have Robo-master and LWPolyline turned off.

    If that doesn't work, and you have laser off at 0 then email the DXF to me and I will take a look.



  • Sembra molto interessante, il taglio finito cose?
    E fatto su cartone o legno?


Log in to reply
 

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.