EleksROM V3.6 丨 Full AutoMactic Upgrade And Set Param SoftWare - Download && Instruction
you need type the "E3" in Gcode Sender~
For EleksCAM you can send Gcode Here:
For Candle you can send Gcode Here:
E3? I did try A0 and it didn't help.
@heedaf E3 is the command for the EleksEgg, it sets Cartesian XY axis and servo mode. A1 switches servo mode but doesn't change the XY setup. A0 sets laser mode (non-servo) only.
A0 Laser Mode
A1 Servo Mode
C0 XY Machine Mode
C1 CoreXY Machine Mode
E1 EleksLaser Default: 80/80/Laser Mode/XY Machine Mode //x,y step/mm /Model /Machine Type
E2 EleksDraw Default: 100/100/Servo Mode/CoreXY Machine Mode //x,y step/mm /Model /Machine Type
E3 EleksEgg Default: 20/20/Servo Mode/XY Machine Mode //x,y step/mm /Model /Machine Type
E4 EleksMill Default: 400/400/400/Laser Mode/XY Machine Mode //x,y,z step/mm /Model /Machine Type
@Zax I type E3 and hit send but the servo just keeps rotating clockwise no matter what the laser power is set to. Any other ideas?
Sounds like a bad servo, most likely the encoder has failed.
I got a new servo and it is doing the same thing. Any other ideas?
Any chance you're connection it backwards? Reversed.
how to set the pen command
i have eleks maker drawing robot plz specify me how to set pen command becuse when i start the writing pen is not moving its show like laser is working ...:
@EleksMaker-Z hi this is adil here
i have some pen servo motor problem kindly send me details how to set pen command when i use this with pen servo motor not woking kindly send the command