MG90S Servo. M3=Top, M5=Down. Which command for Middle?
I could see the specs of MG90S (https://engineering.tamu.edu/media/4247823/ds-servo-mg90s.pdf) servo used in EleksDraw, it is capable to go to 3 positions depending on pulse length:
-90 deg (~1 ms pulse) is all the way to one side.
0 deg (1.5 ms pulse) is middle,
90 dev (~2ms pulse) is all the way to other side.
Sending the M3 command moves the arm to one end.
Sending the M5 command moves the arm to opposite end.
Is there any command to move the arm to the MIDDLE? (M4 works same as M3 )
Any hints much appreciated.
not that im aware of. It is supposed to be an on off not a halfway switch.
@mku Use the S values to set intermediate positions, that changes the PWM.
@Zax BRILLIANT. THANK YOU.
Will try that.