EleksLaser Mana SE controller Firmware A3 Pro 5500mW
i just bought the following laser from Gearbest: http://www.gearbest.com/3d-printers-3d-printer-kits/pp_597312.html
A3 Pro 5500mW
I need a functional firmware for this following controller: Mana SE
Which Firmware and Software should i use?
I tried every single firmware i found, one time the laser is on and at the next firmware the axes are moving but the laser is off.
Thanks a lot.
With kind regards,
Elekscam, it is free and is designed by eleksmaker
Ok i'll do that, could someone send me the original firmware for this board, or an optimized version?
Thanks a lot
You can try this latest firmware of Mana SE:
used your firmware and software.
now i can turn the laser on and off, and move the axes, but the problem is when i start engraving it doesn't move. it lasers on one spot.
@marcel sounds like you may need to change regional to use . Instead of ,
@pledgy how does one change the regional setting on a windows system?
@mrmister thank you very much, you solved the problem!!!!!