Drawing Machine not work and very hot!



  • They assembled that EleksDraw XY Plotter Pen Drawing Robot Drawing Machine and it did work well at first time, but at the second try, the servo which it let pen go up and down did not work, and they found the motor is becoming very hot. The code written on motor is “MG90S”.:cry:
    Is it possible for you to confirm the solution of this problem ?
    Or, could you please inform me the contact person


  • Developer of T2Laser Software

    @Suky It sounds like you didn't adjust the "power" and over rotated the servo, it is probably damaged. Good news is a better quality hobby servo is cheap, but be sure to set the maximum power to prevent over-travel.



  • This post is deleted!


  • @Zax The machine has just been bought a month. Is there a maintenance center to help us on Osaka?


  • Developer of T2Laser Software

    @Suky I highly doubt there is any maintenance center anywhere for these, they are sold as kits. You can replace the servo for ~$2 if that's the problem.

    Be sure to set the firmware to EleksDraw (servo) mode and change the software laser max to 50 and you won't damage the replacement servo.


Log in to reply
 

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.