Servo not working in Eleksdraw
-
HI Everyone
i just bought an eleksdraw and i just finished mount it but when i start to print the servo doesnt move or do anything
can someone help me please?
-
@Akhilesh-Jhuree You probably didn't configure the firmware, if it's in laser mode it can easily strip the gears inside the servo so it may now be damaged. If you hear a noise but it doesn't turn, that's the problem.
-
i dont hear any noise when i turn the servo manually it does work but when it tried to used it it doesnt work
i think i might have mount the eleksdraw wrongly because i have done it while watching a tutorial on youtube
can you help me me configure it ?
-
@Akhilesh-Jhuree I can only provide support when using T2Laser software.
https://www.dropbox.com/s/2ljv0huyyocg0rm/T2Laser_EleksDraw_Setup.pdf?dl=0
-
hello its still not working
the servo is to even making a move
-
@Akhilesh-Jhuree So are you are using T2Laser software, followed my setup procedure to configure the firmware and are using a new (known good) servo? If so, it should work.
-
Its a new Servo still not working
i have followed the steps one by one still not working
-
@Akhilesh-Jhuree Is it connected properly? Maybe reversed?
-
https://imgur.com/a/RRIawK9
https://imgur.com/a/tgghb5G
https://imgur.com/a/LxYFvMvhere is some photo
-
@Akhilesh-Jhuree Check that servo plug, I believe the wiring is GND/5V/PWM which is usually Black/Red/Yellow but they sometimes use different colors so you'll need to verify.
-
ok ill check
but ill send you a video
what is happening?
https://drive.google.com/file/d/1DWjUZ1KqKd3OEWV9N5wChfxPDVbAJGWp/view?usp=drivesdk
-
hello is anyone here?
i really need help
-
@Akhilesh-Jhuree I can't access your Google drive, perhaps someone else can and will be able to help.
-
can you send me your email address ill send you the video ?
-
@Akhilesh-Jhuree I sent my support email address to your PM, I can only help if you are using T2Laser as I don't know any other software.