A3 Pro startup when using T2laser



  • Hi. Is there a particular startup (I mean, not the first time, installing driver and firmware) sequence of the A3 Pro, considered to be safe, using T2laser? Something like "start T2 laser, laser to low power, then power up the controller...", avoiding possible damages, strange movements and so on.
    Thanks a lot
    Marco


  • Developer of T2Laser Software

    @marco_b I don't power on the laser until I am in the laser control screen, that is the safest method. If you have a pull down resistor on the laser then it doesn't matter as there won't be any unexpected laser flash / pulse or movement.



  • @Zax thanks a lot


Log in to reply
 

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.