Striping of images



  • I burned an image on wood and leather and both times the image turned fuzzy (striped) about half way through. Since it wasn't in the beginning, I know that the laser was focused. I cleaned the laser with a soft cloth and it did it again. Is there something else that would change or mess up mid-stream? I am using a 10mw laser. Thanks.


  • Developer of T2Laser Software

    @blackstock Without seeing the result it's hard to say, it could be your Y-axis steps or perhaps a laser issue.


Log in to reply
 

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.