Eleksrom G10



  • Just discovered that the Eleksrom firmware does not support the G10 P0 L20 X0 Y0 Z0 command to set zero only G92. I like to experiment with different software and Universal Gcode sender uses the G10 to set zero which returns unsupported command on the eleksrom firmware. G10 command works on GRBL 0.9i which it is based on and 1.1. Just wondering if there was a reason for this, I use 1.1 on my laser so not a problem but I use Eleksrom on my Eleksegg although I have got GRBL servo 0.9 on it at the moment to test a question someone on here asked and G10 is working on that.


Log in to reply
 

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.