X-Y Motor don't move
X and Y motors run only in manual mode.
In auto mode (START) laser seems to works oke, but no movement....????
Using Eleksmaker CAM v3.1 on windows 10 Home
Someone who knows WHY?
Of course, @diy-laser. I know and if you seek and read carefully in this forum, you also will know as that situation is described here more than ten times... Good luck.
And if you are lack of luck, then click here...
@MuuSer Thanks...it runs now....and i feel stupid..:)
i have the same problem, what did you do to fix it ??
Change windows regional settings from , to .