Laser always on.

  • I just got a 5500mw laser engraver that uses the Eleksmaker mana se. After installing the eleksmaker software and updating the firmware on my engraver I turned the power switch on. My laser comes on at full power and will not shut off using the software commands. I am wondering if there is a problem with the arduino controller.
    Has any one had this issue and if so how do I fix it?

  • @akwdesigner I too have the same issue. I got the 2500mw unit. Im talking with tech support and its not going well. little or no response. I asked if it was the laser/ software/ or board. Its been 3 weeks of back and forth asking for videos pictures. still no response. I will keep you updated if I find out.

  • Active Member

    This post is deleted!

  • I feel so stupid. there are two buttons on the top of the laser chip. the one on the left is an always on button. I pressed that button which switches the lase into command mode and then it responded to the software.

Log in to reply

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.