Bedroom door signs
Christmas gifts for the nieces and nephew. Door signs. The mincraft one was hand painted. The rest was just spray paint.
Made on a 2500mw machine with L7 board. I believe my settings were 750 mm/min full power. Software was t2. For this prject I used air assist and masking tape to prevent smoke burn. The stuff around the R in Rylee is tape adhesive that I hadnt fully removed yet.
wow , i like the MC one best~
Did you spray paint the boards before engraving them? I suppose you did otherwise you'd have a difficult time getting everything looking correct.
Also, you used masking tape to limit the smoke burn. What kind of masking tape? I've tried a couple of different kinds but haven't had much success.