candle and elekmill configuration



  • How to connect eleakmill to candles ?
    I selected com 3, but if I try to use the arrows it does not move...
    (Com 3, same port that I used with the laser that after just two days just the time to make some engraving and broke: ( )
    Now hoping that it will not break even the motor, I would try to use candles with artcam


  • EleksMaker Customer Service

    Please set the baud rate to 115200



  • Ok now candles recognize cnc,
    I did a simple artcam project to engrave a logo,
    I saved the tool path in artcam G code (mm * .Tap)
    I open the file so created with candles
    I position the drill bit on the surface of the workpiece and push XY 0 and Z 0
    After clicking send

    The cnc run, but it drops from what set with xy 0 and 0z.
    What's wrong
    These are the project files and paths
    .[1_1495646188655_PROVA CHAKRA PERC.tap](Uploading 100%) ![0_1495646188654_chakra modello.art](Uploading 100%)



  • Succede anche a me Carlo succede questo e non so il perche' di tutto cio'. Tu hai il firmware 1.1e? oppure 0.9j credo che candela abbia dei problemi con il nuovo firmware 1.1e.


Log in to reply
 

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.