candle and elekmill configuration



  • How to connect eleakmill to candles ?
    I selected com 3, but if I try to use the arrows it does not move...
    (Com 3, same port that I used with the laser that after just two days just the time to make some engraving and broke: ( )
    Now hoping that it will not break even the motor, I would try to use candles with artcam


  • EleksMaker Customer Service

    Please set the baud rate to 115200



  • Ok now candles recognize cnc,
    I did a simple artcam project to engrave a logo,
    I saved the tool path in artcam G code (mm * .Tap)
    I open the file so created with candles
    I position the drill bit on the surface of the workpiece and push XY 0 and Z 0
    After clicking send

    The cnc run, but it drops from what set with xy 0 and 0z.
    What's wrong
    These are the project files and paths
    .[1_1495646188655_PROVA CHAKRA PERC.tap](Uploading 100%) ![0_1495646188654_chakra modello.art](Uploading 100%)


Log in to reply
 

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.