40 watt Chinese laser cutter
I have one a cheep Chinese 40 watt laser cutter, and the software and control board is not the best. Will the EleksMana se be powerful enough to run this device?
I use an older Eleks L6 board to run mine as I have a z-motor for the bed. The Mana SE should work just fine, or for an easier solution look at the http://cohesion3d.com/cohesion3d-mini-laser-upgrade-bundle/
It uses Smoothie firmware which has a Grbl mode, I don't know if EleksCam will work with it but I am planning to support soon with T2Laser.