the laser is not working



  • Hi Everybody!
    I bought an Eleksmaker A3 Pro 2500 mW. I downloaded the software, i installed it. And i was watching the tutorial video, but when i am pushing the start bottom, it is not doing nothing, the laser is not working. Can somebody help me, how is it working? Maybe i did not do something properly.


  • Active Member

    @Barbus

    what software are you trying to use


  • Active Member

    FIRST follow these STEPS

    DO NOT SUPPLY POWER TO YOUR LASER OR THE CONTROL BOARD UNTIL INSTRUCTED TO DO SO BELOW

    Change Regional Setting DECIMAL , to .
    Install Eleksmaker Cam software on your computer.
    Right click elekscam icon on deskstop, select PROPERTIES, select COMPATIBILITY, check the box Run this program as an administrator, click APPLY, click OK.
    Open elekscam.
    Plug the USB into the NANO.
    Plug USB into your computer.
    In elekscam click SETTING section
    Install the DRIVER.
    CLOSE elekscam.
    OPEN elekscam
    In elekscam select COTROL
    In COTROL select a PORT -DO NOT CLICK THE REFRESH SYMBOL, DO NOT CLICK THE REFRESH SYMBOL.
    In elekscam selct SETTING
    In SETTING click RST ROM - let the software run.
    After software installs CLOSE elekscam.
    Open elekscam.
    In CONTROL, look for PORT, select the appropriate COM port.
    PLUG IN THE POWER TO YOUR LASER.

    Your laser should now be ready for use.


Log in to reply
 

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.