Cutting method



  • Hi all,
    I have an A3 5500mw laser engraver and I would like to ask if there is any way with T2Laser to engrave only once the inner lines of my work piece, running with lower laser power, and after finishing it to be followed by a cutting procedure with full power by 4 or 5 or 6 passes?


  • Developer of T2Laser Software

    @Antoniozkzs If it's a raster image you can do what you want using Sketch Plus to trace the outside contour and set lower feed rate and multi-pass for vector cutting. If it's all vector then you would need to make them different colors and split the job using the select color mode so you can set different parameters.



  • Thank you Zax for your quick reply.
    I will follow your suggestions and I hope I will do it right.
    Thanks again.


Log in to reply
 

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.