Driver CH340



  • Good Morning.
    To install CH340 driver, should elekslaser already be connected to the computer?


  • Developer of T2Laser Software

    @nedi It works either way.


  • Active Member

    @nedi

    FIRST follow these STEPS before posting a question.

    1. DO NOT SUPPLY POWER TO YOUR LASER OR THE CONTROL BOARD UNTIl INSTRUCTED TO DO SO BELOW

    2. Change Regional Setting DECIMAL , to .

    3. Install Eleksmaker Cam software on your computer.

    4. Right click elekscam icon on deskstop, select PROPERTIES, select
      COMPATIBILITY, check the box Run this program as an administrator, click APPLY, click OK.

    5. Open elekscam.

    6. Plug the USB into the NANO.

    7. Plug USB into your computer.

    8. open In elekscam click SETTING section
      8a. Install the DRIVER.
      8b. CLOSE elekscam.

    9. OPEN elekscam
      9a. In elekscam select COTROL
      9b. In COTROL select a PORT -DO NOT CLICK THE REFRESH SYMBOL, DO NOT CLICK THE REFRESH SYMBOL.
      9c. In elekscam selct SETTING
      9d. In SETTING click RST ROM - let the software run.

    10. After software installs CLOSE elekscam.

    11. Open elekscam.

    12. In CONTROL, look for PORT, select the appropriate COM port.

    13. PLUG IN THE POWER TO YOUR LASER.


Log in to reply
 

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.