Laser stays on



  • Hello buy an eleksmaker mana and the laser does not turn off when I connect the usb and my machine does not recognize the usb port that I can do?


  • Active Member

    @adomenji

    FIRST follow these STEPS before posting a question.

    DO NOT SUPPLY POWER TO YOUR LASER OR THE CONTROL BOARD UNTIL INSTRUCTED TO DO SO BELOW

    1. Change Regional Setting DECIMAL , to .
    2. Install Eleksmaker Cam software on your computer.
    3. Right click elekscam icon on deskstop, select PROPERTIES, select COMPATIBILITY, check the box Run this program as an administrator, click APPLY, click OK.
    4. Open elekscam.
    5. Plug the USB into the NANO.
    6. Plug USB into your computer.
    7. In elekscam click SETTING section
      6a. Install the DRIVER.
      6b. CLOSE elekscam.
    8. OPEN elekscam
      7a. In elekscam select COTROL
      7b. In COTROL select a PORT -DO NOT CLICK THE REFRESH SYMBOL, DO NOT CLICK THE REFRESH SYMBOL.
      7c. In elekscam selct SETTING
      7d. In SETTING click RST ROM - let the software run.
    9. After software installs CLOSE elekscam.
    10. Open elekscam.
    11. In CONTROL, look for PORT, select the appropriate COM port.
    12. PLUG IN THE POWER TO YOUR LASER.


  • Hi Mrmister, good job. There is a similar step by step to EleksCNCrouter and EleksCam ? I am having problem to run this folks. Thank you


  • Active Member

    @algo

    I do not know.


Log in to reply
 

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.