When you press the Start button in EleksCam, the X and Y motors are not working.
Servo works properly.
In the control menu when I press the x or y arrow, the motors move.
Is the program installed correctly where the problem?
@Andrzej That sounds like the same problem that has been reported more times than I can count. It's a bug in the software that has a workaround, search and I am sure you'll find it.
Use the search function for this forum
motor not move
Thank you for the hints, I was looking in the post, but the problem remained.
Software I have installed on windows 10 64-bit.
After loading G code everything works.
When I load the image, only servo is running.
@Andrzej, you looked, but what have you done to fix this. Just looking did not fix any problem...
If you look your G-code that works and if you look G-code that EleksCam made from image and sends to your EleksDRAW, what difference you see?
The regional settings decimal separator in Windows has to be . not ,
@Andrzej The regional settings decimal separator in Windows has to be . not ,
@2Rex Thank you for the correct answer. Now everything works properly. Once again thank you and greet.