When you press the Start button in EleksCam, the X and Y motors are not working.
Servo works properly.
In the control menu when I press the x or y arrow, the motors move.
Is the program installed correctly where the problem?
@Andrzej That sounds like the same problem that has been reported more times than I can count. It's a bug in the software that has a workaround, search and I am sure you'll find it.
This post is deleted!
Thank you for the hints, I was looking in the post, but the problem remained.
Software I have installed on windows 10 64-bit.
After loading G code everything works.
When I load the image, only servo is running.
@Andrzej, you looked, but what have you done to fix this. Just looking did not fix any problem...
If you look your G-code that works and if you look G-code that EleksCam made from image and sends to your EleksDRAW, what difference you see?
The regional settings decimal separator in Windows has to be . not ,
@Andrzej The regional settings decimal separator in Windows has to be . not ,
@2Rex Thank you for the correct answer. Now everything works properly. Once again thank you and greet.
The EleksCam laser does not engrave. While working, the laser displays a point, but does not engrave. I would like to ask what should be the settings in EleksCam v.3.1 to make the laser work properly.
To solve this problem you must go to the control panel
watch, language and region
change date, time or number formats
CHANGE , FOR .