Error T2LASER specular image burn
Re: T2Laser Software - Introduction
S sorry for my bad english. I have a problem with t2laser software. Image burn in reverse/specular mode.
@antonio It sounds like you don't have the machine setup correctly, if the jog keys don't match the directions you can reverse them in the Settings menu. Once left = left and up = towards the back of machine the images will be correct as well.
You should be using my default firmware, Grbl 1.1e - so if you haven't loaded that, do it first. It may fix the directions.
@Zax. Axis direction x y are right. problem comes when it burns and picture do the specular. Try it with your firmware and hope for a good solution.
@antonio I will ask again, did you load the Grbl 1.1e firmware?
You obviously have one of the axis reversed, make sure your control board is at the back of the machine and then get the direction arrows jogging correctly. Then it must work correctly, if jog is correct then the output will be correct.