conect new laser module
my laser died, and i bought a new one.
but i don't know how to conect.
Has anyone done this?![alt text]( image url)
You will need the - and S pins on the shield to connect your driver, make sure you have the polarity correct, on the yellow / white wire, which you should be able to see on the driver board, - goes to - and the + on the driver board goes to the S pin on the shield.
This post is deleted!
It doesn't really matter the design, they all have TTL input (+ and GND, sometimes labelled -) and power + and GND or -.
You connect power (less than 3.5W is OK to use the laser port + and - pins.
Connect the S-pin from the Mana SE to the TTL +.
If it doesn't work add a wire from TTL - to the Mana SE - or your power supply GND/-.
It works! Thankyou
Can you put a picture of how you connected it? I have the same laser and I am not able, thanks