T2 Laser eleksdraw



  • I am trying to test the t2 laser program with ElexDraw but I can not set the correct firmware
      T2 and eleksdraw work diagonally
    Atmega328 firmware did not do the picture digging

    Except for 1 bit bw, grayscale printing can be done
    Do you intend to prepare an instruction for use?


  • Developer of T2Laser Software

    @nebiaydogdu Did you follow my build instructions? The last page explains how to setup the software.

    You must install the firmware and then click the EleksDraw option in the menu.

    0_1503617347795_t2laser_eleks_firmware.jpg

    0_1503617368014_t2laser_eleks_menu.jpg



  • It was not going to happen anymore.
    I installed xLoader with cleareprom.hex and reinstalled the firmware again
    Problem resolved


Log in to reply
 

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.