Skipping lines / Steps (GRBL loaded) (Laserweb 4.0)



  • Hey all, Having an annoying issue currently.
    As you can see I am consistently getting broken lines in my cuts/rasters/fill paths.

    I have tried tightening and loosening the belts
    Adjusting current limits
    Changing speeds / Power outputs
    Configuring idle speed = 255 etc

    My grbl Config is as follows :
    $0=10
    $1=255
    $2=0
    $3=0
    $4=0
    $5=0
    $6=0
    $10=1
    $11=0.010
    $12=0.002
    $13=0
    $20=0
    $21=0
    $22=0
    $23=0
    $24=25.000
    $25=500.000
    $26=250
    $27=1.000
    $30=1000
    $31=0
    $32=1
    $100=80.000
    $101=80.000
    $102=250.000
    $110=30000.000
    $111=30000.000
    $112=500.000
    $120=900.000
    $121=900.000
    $122=10.000
    $130=200.000
    $131=200.000
    $132=200.000

    0_1504340173988_21284567_1524648727593726_571966669_o.jpg


  • Active Member

    This post is deleted!

Log in to reply
 

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.