T2 Laser, Strong Laser point after clicking "Control Laser"
Every time i load up an image or anything else and click on the button "control laser" to get the g code and the control menu, the laser burns a hole at the point right where it is at. It just turns itself on for 2 seconds and off again, but it is very strong and burns holes at every starting point.
What could cause this problem?
I hope you guys can help me, thank you
Problem with electronics not T2Laser software or other software. Problem known long time.
just keep the power button off until after it connects. This is a hardware design flaw. The old machines didnt do that but the only way to stop the new ones it to install a resistor or just keep the power off until it connects.
thank you very much
Io ho risolto grazie dell' aiuto di Zax mettendo una resistenza da 1K ohm nella scheda Mana. allego una foto della modifica che ho fatto io nella mia scheda Mana.
@ianobre The problem is really the laser driver, so yes it will work on any board.