Speed on Y axis and relative burn out on wood.



  • Hi,
    I'm Andrea and I've an EleksMaker A3 Pro 5500mW. I've resolved some issue using this newsgroup (like using . (dot) instead of , (comma) inside SO) but I've not found anything about this "problem" (picture attached).0_1505816874674_20170919_120029_cr2_cr.jpg
    The cut in X is sharp and fast, in Y is very slow and with some hot problems :)
    How can I do to speed up the cutting in Y axis? Always if this is possible.
    Best regards.

    Andrea

    P.S. sw used Elekscam v.3.1


  • Developer of T2Laser Software

    @manto_laser T2Laser has an option to automatically adjust for the grain, it will use a higher feed rate (or less power) in one axis vs. the other. I don't think EleksCAM has any adjustment for this.



  • Thanks Zax for your tips. I download immediately this sw.
    Thanks again for your attention.

    A.


  • Developer of T2Laser Software

    @manto_laser 0_1505841846542_vector-adjust.jpg

    Here you can see how it adjusts for different angles.

    It is just a circle but as the angle changes so does the power or feed rate, all automatic - you just enable it and tell it what adjustment you want.0_1505841943298_axis-angle-adjust.jpg


Log in to reply
 

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.