Laser on A3 stays on even when not engraving



  • Hello,

    After installing EleksCam I am having issues with my laser. It stays on all the time now, unless I physically turn it off.
    As soon as I uninstall and return to benbox this issue no longer occurs.

    Please help.


  • Active Member

    which control board do you have? Did you install the elekscam firmware onto the nano when you switched to Elekscam?



  • Solved! I had to remove the MicroUSB board, change the pin over to .8 and reset the rom via EleksCam software. Works great now.

    Major improvement from Benbox, but the scrolling is still weird, and no tool tips or proper tutorial.


Log in to reply
 

Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.