You wrote, "The Bluetooth Connecter is in 5V GND RX TX Series".
The pinout drawing of the Mana SE shows 5V GND "TX RX".
Which of the two is correct?
I followed the Mana SE pinout drawing. The HC-06 Bluetooth module pinout is the same as the Mana SE
drawing pinout. The HC-06 is paired, Baud Rate 115200, Ardino ROM is GRBL v1.1e, T2 Laser says it is
connected on the HC-06 bluetooth COM port, and NO go (the two pads beneath the Ardino module are open,
NOT jumped). With the HC-06 connected, both LEDs on the Ardino module are on when the power is applied (with
no USB cable connected).
Am I missing something? The green Ardino board LED blinks when T2 Laser sends a command but no
machine response. What else needs to be done? Are the TX RX pins reversed in error on the Mana SE
connector drawing and therefor reversed on my implementation? Is GRBL v1.1e the wrong firmware?
Thanks for the help,
Black Canyon FX