I used a volt meter and adjusted to .65V, as was shown in the video. It was around .29V before. Only the Y axis is not working. Will try disconnecting the belts, was afraid I'd burnt the stepper motor out but wanted to confirm before I continued to disassemble.
Posts made by Chris Fendley
RE: New troubles with Y axis
New troubles with Y axis
I was having trouble with the Y axis only moving in one direction, and found the topic posted on here by pesbes and answered by Zax. The adjustments in that post fixed my problem, and I got through half a burn before the Y axis stopped moving entirely. I have the top half on an image and then a straight horizontal line. After stopping the burn, I am now unable to move the table with the controls, nor does it move when I select "preview". Resetting the power did not solve the issue. Any ideas?