Well the laser is up and running, no real issues with that. Installed the EleksCam s/w to start with, no real issues with that either so went ahead and installed T2 1.5m from Zax's server. No issues other than needed to be online. Maybe a better error message Zax? I looked at the log file though and it was pretty obvious what it was complaining about!
Uploaded 1.1e grbl
Just a couple of things:
When ever I go in or out of Laser control the laser comes on in full burn mode. That's a bit annoying if the work piece is in place.
The stop button (red hand icon) doesn't work correctly. Clicking it once does nothing, twice seems to work, but hangs s/w same as esc key. Esc key works first time and the laser stops. However the s/w seems to hang. The exit "X" top right and the other window controls (min/max) have gone and there is no way to stop the software except cntrl, alt, del.
Is there also supposed to be a way of restarting the burn where it left off after a stop (pause)? |say to adjust the air blow?
Dell, windows 8, convertible laptop, 32 bit
T2 version 1.5m (TRIAL)
I haven't changed any jumper settings on the control board from as it arrived - should I?
Thanks very much