Does anybody have a video or pictures of what their machineslook like with the laser on it?
Posts made by ElecEngStudent
RE: EleksDraw Pen Plotter (adding the LASER module?)
EleksCAM not accurate
My eleksCAM is working with my EleksDRAW but the lines arent very accurate in regards to the drawing in EleksCAM and even when doing text drawings the lines look messy.
I am wondering if there is a set up issue that I am missing or have not done?
When setting up EleksCAM i shut the laser off, set the home coordinates, select the machine, choose my x-rev and y-rev, set the servo to 20, and go.
How should I set up my EleksDraw with EleksCAM?
I am trying to figure out what software to use for my Eleksdraw machine. I am seeing various combinations that people are using.
What should I use and how do you use it?
I have inkscape already downloaded and GRBL but I am finding it difficult to understand how the two work..
RE: EleksDraw through Arduino Uno
The project I am doing requires me to utilize the Arduino Uno.
Currently I purchased an Arduino Shield, L293D motor driver shield, and am trying to run the Arduino through GRBL programs to send G-Code to the Uno.
I am having no response from the Arduino.
EleksDraw through Arduino Uno
I am working on a school project where we have 5 EleksDraw machines, 3 Arduino Uno's, and one Programmable Logic Controller, that all need to communicate with each other for operation.
I was wondering if any one has swapped the EleksMaker Mana SE board for an Arduino to control the stepper motors and servo?
If so, how did you do so?