Hi
I would like to know why my laser makes thin stripes when moving from one letter to the next letter?
Does the laser switch off when moving between the letters.?

Hi
Where can I download the operating instructions for my eleksmaker A3PRO.
Thanks
Jannie

@John
Hi John
Thanks for the info. Is than any explanation for the settings on my program.
I am using Eleksmaker Evolution Desktop CAM V3.1.
Is there upgrades to this prog?
Thanks Jannie

@MuuSer
Thanks a lot. Got it to work after changing it.
Thanks

Hi
Up and running now.
Few questions please.
Q1. On the X axis motor. Sometimes it hums on one position the I need to push it a bit to get it to run. Do I need to turn the X axis potentiometer a bit to up the current so that it could turn on its own?

Q2.The laser beam. When adjusting it to focus I get it right to nearly make a pinhead size focus but it shows a blurry stripe to the one side. Is this normal?
I have got 2 NEJE engravers which I get that adjustment nice and fine.

Q3.My driver is a Eleksmaker Mana SE. So this card drives the stepper motors. On my laptop I have got the Elekscam program. I see there is a Benbox program also. Any sugestions other than or any one of the two programs?

Q4. Is there any paper downloads of how to use the Elekscam program?

Sorry for these questions , I am new to this laser engraving and would like to learn more about my machine.

Hi
I need to download the software and all the stuff to get the engraver to start working.I bought it through banggood and the site they give me to download it from gives me nightmares.
Please could someone give me an easier way to install the drivers and all I need to get it to work.
Thanks
Jannie