@criskof Refer to the settings I listed above (back in October) The main thing is having the laser turned on via (what I think was output 11).
Posts made by JimWrey
RE: EleksLaser A3 Pro Laser is always burning
Assembled my A3 pro laser. Had same problem with full power burning.
I found that the configuration on Benbox 3.7.99 was wrong for the new Mana SE board.
On the second page of configuration where it lists and sets:
X Y and further down the page 0 and 1
I used these new settings (new for me as they were all -1 when I started up the program.
STEP 2 3
DIR 5 6
MIN -1 -1
MAX -1 -1
PPM 320 320
LASER 11 11
SERVO 15 20
Then be sure that the laser white pushbutton in UP (low light off) and laser power button on Mana SE board is on and blue led's on board are on.
That solved my problems. Your mileage may vary...