So when I click on register... how do i get my key code?
In the payment section it says something about shipping? I only want the license
Posts made by mawu
T2 Laser png problems
I made this birthday card in IncScape in correct scales and with the size 80x50mm.
Now I exported it as a png and loaded it into T2Laser via image import.
But even after setting the right output size in T2Laser, the image is blurry and not recognizable... I don´t know what mistake I am making.
Thanks for your help
T2Laser Resolution Issue
so I want to raster engrave this birthday card for someone and i try to make it nice and with a high resolution.
But I have the problem, that every time i set the setting to a higher resolution I get nly half of the picture in the "view and simulate" window after clicking on "generate gcode".
Following pictures show my problem. one is 0.2 res, one is 0.1 res.
Hopefully you can help me.
T2 Laser, Strong Laser point after clicking "Control Laser"
Every time i load up an image or anything else and click on the button "control laser" to get the g code and the control menu, the laser burns a hole at the point right where it is at. It just turns itself on for 2 seconds and off again, but it is very strong and burns holes at every starting point.
What could cause this problem?
I hope you guys can help me, thank you