I reset the firmware.
I tried to cut a circle, but after two successes, it started to stop again.
I tried to upload the default firmware, but I get an error.
Since it succeeded twice, is it being improved little by little?
Connected COM3 115200
Grbl 1.1e Ready
Unable to process status message
There is such a display, and when I press the button to send a G code, it moves to the start position. And it emits laser light and stops immediately. Since the laser light is coming out, I press and stop the emergency stop button. It was the same even if I changed the laser module.What is the cause?
Thank you zax and MarcFr.
It now works when loading the firmware. I could adjust the intensity of the laser light. However, when I try to engrave, everything stops. It is "sending". What should I do?
Also, EleksCAM does not even recognize ports. Why is another board to recognize?
Thank you for your advice.
Thank you zax.
I'm in trouble! help me.
I have an A3pro and an unknown laser engraving machine.
The other day, I bought eleksmaker mana se v3.2. (The surface is black.)
I replaced the board with the board of an unknown laser engraving machine, but EleksCAM, Benbox, and T2 Laser also do not move.
What's wrong? Is it broken?
By the way, A3pro I bought before is moving. (The surface is a blue board.)
Someone, please tell me what to do. Please.
Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.