In the recording of texts, approximately 12 words, some letters (normally the same as q - f - t) are left with their lines out of focus.
Has anyone ever experienced this?
The Y-axis of my equipment does not travel in the CNC mode, it travels with command Manual through the benbox arrows.
What could be happening?
Thank you for your help.
In fact, I'm not using any software, because as I turned on the button on the laser module it did not turn on, I stopped the tests. I already sent a video with the problem to Banggood.
What software do you recommend for EleksCAM or Bembox?
Where do I find good installation and operation instructions?
Is it possible to test the motors / shafts without the laser module? Are they independent functions?
Good Morning. I received and set up my equipment today (A3 2500). I energized the equipment, the board ignited and the laser did not start. I've already got in touch with Banggood. Would you like to know which software is easiest to use to operate the equipment? I can test the other functionalities of the equipment (movement of the axes / motors) while the laser.
Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.