Thanks Zax! Will I need the AVR programmer to initially program the replacement Nano, or will flashing the proper firmware be sufficient?
I had selected the 1.1f Laser Axe firmware, thinking that this would enable better control of the unit. It looks like I goofed there, or it apparently just didn't finish the upload.
I did follow the forums and try to clear the EEPROM or flash another ROM, but each one ends with a "Firmware Upload Error 1/0".
Unfortunately, I don't have access to another device or a programmer. Is replacing the board my best option? If so, are these boards equivalent?
Thanks for the help, sorry for my ignorance
I have a new A3 and have been able to make successful burns with Eleksmaker, Lightburn, and T2 earlier today.
I attempted to use T2 to update the firmware, but received an error during the process. I can still connect to the device (in T2 or Lightburn), but instead of moving the laser as before, the X-axis buttons only move the Y-axis, and only in one direction (toward the rear of the work area. The Y-axis buttons do nothing.
Attempting to upload the firmware in T2 (to 1.1e default)
or in Elekscam 3.1 fail. Even using Xloader to upload the EleksROM.hex file do not complete.
I was just getting to enjoy this machine! Any tips on where to start? I'd greatly appreciate any help!
Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.