I apologize for assuming that you were directly associated with Eleksmaker, my fault. I was just trying to use one of the software programs that I am more familiar with. I have 3 3D Printers, a Geeetech M201 , a Folgertechnology FT-5 , and a Smapmaker 3 in 1 , printer,laser and cnc . Plus an Endurance 3.5 watt Laser DIY engraver/cutter. I was having problems with the 3.5 watt laser and referred by Endurance to RobotsEverywhere, the original developer of this laser, who replaced the laser. I was then trying to upgrade LaserGRBL from v.9 to v1.1 using Arduino on 2 ATmega328P processors, and they no longer perform properly. During a discussion with Robots Everywhere he recommend the Eleksmana board, I tried EleksRom app twice, but it does not install v1.1 of GrBL, all the new functions and commands are missing, so to me it's still v.9. I can install 1.1 with Arduino if I know I have the proper sketch settings for it. This board responds the way I like and I don't want to damage it
Posts made by Obewon
-
RE: firmware upgrade
-
RE: firmware upgrade
Dear Sir : We both know Arduino gives access to many options for the programmer ,as well as platform, and processor options . I have been asking these question's , because I know I am not an expert and at the same time I know enough to ask ,when clarification is needed !! I am77 years old and my electronics training took place between 1973 and 1975, and I have not kept pace with it ! BUT, I also know you are there to sell more product, and you could help yourself by being more open about your products and what they do and how they do it ! You give No information 1) what your boards are structured on. 2) your programs have NO brief description of what they do !
-
RE: firmware upgrade
Thank you ,so to upgrade to Lasregrbl v1.1 my sketch setup should be
(1) Platform : Nano (2) Processor : ATmega 328 (NOT ATmega328P ?) and Programmer :
? which one ??
-
RE: firmware upgrade
@Zax Ok, I pretty well know how to install firmware with Arduino so what I'd like to know is can I use Arduino and if I can what type of board ,processor and programmer do I use to install v1.1 of LaserGRBL. IF Arduino can't be used then what do I use ? I could not determine that from anything on the site !
-
RE: firmware upgrade
@Zax Can you tell me what version of Arduino chip is used on theEleksmana v5.2 board ?
-
firmware upgrade
How do I upgrade LaserGRBL from v.9 to v1.1 on theEleksmana v5.2 ?