My EleksLaser-A3 Pro works fine for pictures. But I need to cut
circles and arcs, and the gcode commands G2 and G3 do not work.
Can these commands be enabled for this machine?
Be sure you are in servo mode. Run a text print of 1 character. If the character prints , look the Gcode log. You will see that the G code sends M3 to enable pin then S0 is pin up, S1000 pin down.
Finally at the end you'll see M5 which turns off servo.
Hope this helps.
Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.