@Kerteszradio I had the same problem with my 5500mW laser I received a couple of weeks ago. The problem was a PWM/TTL switch, which didn't look like a switch (to me anyway). I pressed it while the laser was on and it fixed my problem.
It turns out there is a switch on the laser module to toggle PWM/TTL. I had checked for one before (as others in the forum had mention it), but it didn't look as I had expected. I've posted a picture below to show what it looks like as it may help someone else at some point.
Also, the switch seems to only work when the laser has power to it. Not 100% sure of this, but I don't want to press it again now that its working correctly
I've searched the forum but have had no luck fixing this.
I have the EleksLaser A3 5500mw (Mana SE board).
Heres what I've tried:
So I assume the laser is fine, but the value 12 to value 11 problem remains. Am I able to set that value in T2Laser as i'm able to control the XY Axis with manual arrows, but can't get the laser to turn off.
@TeLLe I'm still learning about these laser products but from what I've read, your not going to be able to cut 3mm ply wood with a 2.5W laser in one pass. According to another forum it may take 6 passes to cut craft plywood with that power laser.
Is the store currently active? I tried to purchase something to ship to Australia and it says there are no shipping methods, please contact support. I tried using the contact page and it seems to fail on submit.
Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.