thank you very much for that, that is alot simpler than i thaught itwould be. i will ry that and see if it works. if not i will post up here.
Posts made by spartan181
Newbie needs help flashing Mana SE
hey there all
I recently got an eleksmaker A3 Pro and i have been loving using it. Almost imediatley i switched to using LightBurn as its a nicer peice of software to use. i noticed a problem after a few runs in the form of asynchronous sizing. everything engraved or cut was a bit larger than was stated on the software. this effect wasnt static it was cumulative for each mm traveled in software the laser would move a little further than that. so i messed with some settings and got it sorted and loaded it back to GRBL 0.9. after this the whole thing felt slower and more slugish like the speeds were not being matched. ok sorry for rabling there.
Long story short i want to flash the control bord to GRBL 1.1. i know someone has mentioned having sizing problems and has gotten some custom hex codes knocking about.
if any help or advice could be given that would be great.