I understand that the engines have a small buzzing or whistling sound, but it is not the motors that buzz or whistle, no, they are the small steep motor, and the master circuit (this is sometimes).
And I tried to adjust the small potentiometers of the engine steep, and even changed them for completely new ones from my workshop, and? ...... nothing, to see if the engines start, and? ...... nothing , I commented that when I do that management, EleksCam has started, the port is located, and the machine, in settings, selected (EleksDraw). I return to the control tab, and try to make a + X / -X, or + Y / -Y adjustment, put 10, right in your locker, and? ....... nothing at all.
I commented that, also, I have not managed at any time to recognize the usb port.
I read somewhere on the official page of EleksMaker, that the power supply, should be at least 5 amps, however, the one that comes, the box I bought, only gives 2.5 Amperes?
Now I'm on a computer where I have Win7 home, and? ... nothing at all, for the umpteenth time.
Truly, this is ... a real annoyance, not to use another less educated word.
I also commented that I am an electronics specialist, I have my own repair shop, two 3D printers, which by the way, it did not cost me anything to configure their software, and that they are cheap, Anet A8 and A6.
I would very much appreciate your cooperation, and put the EleksDraw up and running. Thank you