@Zax Thanks, much appreciated!
Posts made by TobyTobiasToader
RE: Eleksdraw machine is not running.
If the software is properly installed, then maybe you need to go to "settings" tab on the left side and do three things; 1) Re-Flash the ROM, 2) Select the correct machine. 3) Make sure that you choose correct mode for a ink pen (Servo Mode) or to use a Laser (Laser Mode). the difference is that the pen needs to use a servo to lift from the page and the laser needs a signal to turn on or off, Both commands use the same G-Codes; S1000 or M03 = Servo Down&Laser On, S0 or M05 = Servo Up&Laser Off. The difference is for which pins on the system board get the signal. This is also a little bit glitchy, because the Laser connections get some transient voltages when the system is in servo mode and also the servo can get some glitches when the system is in laser mode. The other thing you must make certain that you have the unit turn ON power and usb plugged into PC when you start the software. Try those things first.
Complete List of Supported GCodes?
Re: G-Codes Used
Where can I find a complete list of G-Code commands supported by this firmware EleksCam Evo V3.1 ? I need to use a timer in my g-code file but the system timers #3001, #3002, #3011 and #3012 don't seem to be supported. Does anyone have a complete list of supported g code commands?
RE: Duplicate objects for cut-out
@rlambert I would create the duplicates in another image control suite and then import the pattern of duplicated images. I am assuming your using the EleksMaker Evolution Desktop CAM V3.# suite? I am and have found it to be very rudimentary in terms of image manipulation. I successfully used Windows paint to duplicate my pattern. You have to decide how many you want to put on your cutter at once and duplicate that many and their orientation and save that as a .jpeg or .bmp and then you can import the tiled pattern and go for it!