No I didn't update firmware... maybe that's the issue... I just basically imported it as a JPG and printed from that. I'll try the firmware upgrade - didn't realize that might be a requirement...
Here's a version of what the logo was supposed to look like.
I'll take a peek at the belt tension, etc. but I haven't been running into problems like this on the Elekscam software so I kind of doubt it's a hardware issue.
Thanks for your response.
I'm getting an issue where a couple of my diagonal lines are being doubled when I print with the T2laser software. Here's an image of what's happening:
Does anyone know if there is a setting I can use that will eliminate this doubling effect?
Thanks for your help!
Looks like your connection to Offical Forum was lost, please wait while we try to reconnect.